Christmas 3D cookies
By VicentaLakin
When it comes to winter, it comes to Christmas. Combination of the flat butter cookies with sleds and reindeer, plus Santa Claus, made of sugar, in a tempting winter. Draws the shape of the required components on the paper, cuts them up and acts as moulds, carves them on a thin cookie paste and bakes them together. I'll do it with sugar。
Recipe Recommendations
- butter 70 grams
- powdered sugar 40 grams
- whole egg liquid 30 grams
- low-gluten flour 160 grams
- fondant skin 100 grams
- gum paste 100 grams
- pigment a little
- sweetening
- baking
- an hour
- ordinary
Steps for Christmas 3D cookies
1
Butter softens at room temperature, and then you add sugar and powder
2
The egg fluid was added and then the concussed until the egg fluid was fully integrated with butter and there was no separation of water oil。
3
Sift in low-banded powder
4
Put it in a folded sheet of oil and fold it around 3 mm. In the freezer. It's better to freeze for a while. But there's no room in my fridge, so I can freeze it。
5
And while you're cold, draw components
6
Cut it, try to assemble it and fix it
7
Put the drawings on the face and cut the shape with a knife. If it's frozen, it's easier to cut
8
Rip out the extra pieces and fix the edges
9
Go to the mid-level of the Battrid oven, fire up and down at 160 degrees, bake for about 15 minutes, just a little color. At the right time, we'll need to adjust the length of the cookie
10
Just take it out and hang it out and put it together. If the interface is not appropriate, a small cut-off may be used. But be careful. Biscuit's so thin. Don't push too hard to break
11
When you've got the sleigh side
12
Dry Pess mixed up with sugar peels, with a little pigmentation with toothpicks, and a little modulation in the spinach. A golden bell and a red collar for the reindeer
13
A little green, press an elliptical, cut the leaf shape with scissors, carve the leaf vein. It's brown in three. It's a braid. A piece of the good leaves sticky. Double layers are more stereotic, leaves stick to the tip of the leaf, and the other end goes up
14
Red as a little ball, caught in a sling, placed in the appropriate position and assembled in a sledge
15
By the same token, it's the head. Take two more gills and put your nose and eyes on it
16
Put your red nose on, white with a beard around your face. Red hemispheric hats and white hoods are wrapped up. With a few white eyes, with eyebrows and eyelashes
17
Make bodies and arms in red and white, make little hands in a meat ball, put it in a sledgee, tilt the body a little bit, feel dynamic
18
The wheel, depending on the position of the reindeer, removes a long leash and puts a red ring on the reindeer and binds it. Just a little snowflakeChristmas 3D cookies Make Tips
In order to keep Santa's movement less rigid, he can twist his body to an angle, look slightly at his head, and his left and right hand is not tall. The green tree in the back was made before. No pictures. In order to be proportional, to highlight Santa Claus and sled, the sled becomes hand size, the reindeer is smaller than the thumb, and I'm drunk. It's possible to zoom in the reindeer ratio