Star candy
By VicentaLakin
Recipe Recommendations
- coral sugar 120g
- water 12g
- dark pigment a little
- Edible printing paper appropriate amount
- sweetening
- roast
- three-quarters of an hour
- ordinary
Steps for Star candy
1
Tools and materials must be ready before we begin. Thermometers, pots. And the pots I use are small, non-clattering pots. And I suggest you have a pair of gloves. That's the picture. The pharmacy can be bought. That'll prevent sugar from being touched. To get a straight-fire gun better
2
AND THEN I STARTED TO GET SUGAR. IF IT'S CK, IT'S ABOUT 30 GRAMS. MY MOLD IS FIVE BALLS, 2.8 CENTIMETERS IN DIAMETER. IT'S A LITTLE MORE THAN 120 GRAMS OF SUGAR. SUGAR WATER RATIO 1:10。
3
Temperature to 165 degrees. Take it off and put it on wet rags in order to keep the heat warm. I'll shake the pot when I do. The bubble will go away soon
4
If only you hadn't seen sugar in the thermometer. Remember to heat the fire
5
Put sugar on the unplug side. Fill. The advantage of this mold is that it doesn't need demoulder oil. And it's simple. To keep the sugar cool, I put some water in the oven and the molds on the water
6
It's time to cut paper. The size of the paper is smaller than the mold. Simulator 2.8, paper 2.4. Enough time. Try to cut the circle. Pictures affect final quality。
7
Put the paper on. Heads up
8
After cooling, they continue to struggle with sugar and add dark colour. Or not. Still 165 degrees
9
Two and a half. You can hold your skin tight. Pour it down from the hole into the chromosomal sugar。
10
A little cooling and sticking. Not too deep. Then it's cool. Plug the stick and punch. Stick it in and drop it. Lightly adjust. Be gentle. Then go and do something else. Clean up the table and brush the pot. We'll open it later. Put some water in the pot when you brush it. When the water boils, it melts into water. The pot will be clean。
11
After cooling, when the mold is turned on, the surface of the sugar is exposed to bubbles. It's over if you play by yourself. Take it out and hang it to a completely cool wrapper. The mold is not good. Take it out and keep cooling. Keep it down if you need to。
12
If you want a gift, use a straight-fire gun. Once the surface bubble is burned, it's gone. But be careful to cool down and burn. Don't move after the burn. Until it cools down
13
The finished product。