Homemade oil bars

By VicentaLakin

Homemade oil bars
There's a lot of cooking on the house, a lot of cooking on the Internet, a lot of cool skins, oil bars, electric cakes. No, I've been cooking with the wind. First time, it's a success. The oil bars were made using aluminum-free powder and small sodas as an inflation agent. Aluminium-free powder, commonly referred to as dual-effect bubble-battered powder, is composed of a combination of acid pine phosphate calcium phosphate, potassium thalphate and sodium bicarbonate alkaline pine, ammonium carbonate, potassium carbonate, calcium hypocarbonate and starch. Aluminium-free powder does not contain any aluminium composition and is generally used at 2 to 5 per cent, with little harm to humans from thermal decomposition products. The chemical name of sodium carbonate, which eats small sodas, is sodium carbonate, which is often mixed with sodium melted water into flour when cooking foods such as buns and cookies, which is then heat-decompositioned into sodium carbonate, carbon dioxide and water, and a spill of carbon dioxide and water vapour, which can lead to more Gabonese pine. In addition, small soda removes pesticide residues from food and can be moderate to stomach acid。

Recipe Recommendations

Steps for Homemade oil bars

  • Make Homemade oil bars step 0
    1
    Prepare all the material。
  • Make Homemade oil bars step 1
    2
    All the materials are placed in a toaster mixer, a selection and a face program, and a smooth patch. If you don't have a toaster, just rub it in your hand。
  • Make Homemade oil bars step 2
    3
    Noodles are rounded, oil on the plate is sticky, covering membranes for more than three hours. I spent the night. In fact, I've been running a little bit wrong here, and I'd like to put the pasta into long strips and coated the surface with oil。
  • Make Homemade oil bars step 3
    4
    The styrofoams grow, and the styrofoams are shorter than the oil bars. So, if you're wrong, you can see here that the small pot in the house and the fact that you don't have to put a pot of oil in it makes it look too wide. Another 30 minutes to cover the shampoo and an hour to wake up。
  • Make Homemade oil bars step 4
    5
    CUT INTO A BROAD STRIP AROUND 3CM。
  • Make Homemade oil bars step 5
    6
    Each of them folds, presses with chopsticks, and squeezes with both heads, and becomes an embryo. I was too long and cut in two。
  • Make Homemade oil bars step 6
    7
    The oil temperature rises to over 170°C, as illustrated. I looked at the recipe and said it was 200°C, but it was too high in practice, and it blew up, swollen and dark. The temperature drops and it's fine. But then I made another tart, and the noodles were wetter, so the temperature was a little higher and 170 degrees C was a little lower。
  • Make Homemade oil bars step 7
    8
    It is evident from the light lengthening of the oil bar, and if it does not wake up, it is not easy to stretch it. And don't pull too long. It's almost twice the length. It would be easier to tear down the face of both sides, so that the oil bar would not break apart. Put the middle in the oil first, then take two。
  • Make Homemade oil bars step 8
    9
    Rolling the oil bars with chopsticks to level the heat. Just make it golden。
  • Make Homemade oil bars step 9
    10
    Open up and look at the hole
  • Make Homemade oil bars step 10
    11
    Here comes the crumbs of soybean and the traditional breakfast
  • Make Homemade oil bars step 11
    12
    Can you cook with a tart? It's a veggie ribs made with an old cake, isn't it? Tastes good, too
  • Homemade oil bars Make Tips

    In general, flour is 2 per cent of flour, with the same amount of sodium as powder. The two liquids, including eggs, were about 66 per cent of flour, and there was no harm in having more moisture, and the oil noodles were wet. However, 10-20 grams of water or milk should be left to manoeuvre, and the dry and wetness of the facen should be added as appropriate. The temperature of oil is also adjusted at any time, and it is felt to be higher, lower and higher。